13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
1. Check that all component parts are secure. If the log saw is not fixed to the
floor, ensure that it is placed in a steady position on firm ground.
2. Ensure the power cable is well away from the saw and the workpiece, then
plug into the mains supply.
3. Check that any previously used timber being sawn does not contain any
nails or other metal objects which would damage the blade.
4. ALWAYS check that the saw guard and cradle move freely and spring back
when released.
• The maximum log diameter that can be cut is 170mm, max weight 16kg.
USING THE SAW
1. Turn on the motor switch
• Once motor switch is set to ON the blade starts rotating.
2. Open the top guard, place the log to the cutting position on the log
carriage and close the guard. Position the log so that it will not move while
cutting.
3. If the length of the log is greater than the length of the cradle, extend the
log support yoke and set it's position to suit with the securing knob.
4. Grip the handle at the left side of log carriage and push it towards the saw
blade cover.
• The movable saw blade guard will open and expose the saw blade.
5. Keep pushing with even pressure until the log on the log carriage is cut.
Avoid putting unnecessary pressure on the blade and avoid applying
lateral pressure. Let the blade work naturally.
6. Stop pushing and the log carriage will retract to its original position. Move
the rest of log to the cutting position and continue next cycle until the work
is accomplished.
7. Regardless of the diameter of the wood, only one piece should be placed
on the cradle for cutting at anyone time. Do not attempt to saw multiple
pieces at once.
8. If logs of equal length are required, set the log stop bar to the required
distance. Measure this against the scale on the cradle and lock in position
with the securing knob provided.
Содержание CLS505
Страница 24: ......
