10
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
BATTERY CHARGING
The new battery pack will require charging
before use.
1. Squeeze the battery release buttons on
either side of the battery pack and pull
gently down to disengage the battery pack
from the wrench.
2. Insert the battery pack into the charger, as
shown, noting it will only fit one way.
3. Plug the charger into a 230V (mains) power
supply and switch ON.
• The green light illuminates to show the
unit is connected to the mains supply.
The red light illuminates when the battery
is placed into the charger and remains illuminated untill the battery
is charged. When the battery is charged, the red light goes out and
the green light illuminates.
• If charging does not take place, ensure all connections are clean
and free of grease etc.
• A new battery pack may initially not accept full charge. This is
common and does not indicate a fault. It can be recharged fully
after it has been discharged approximately five times.
4. The red charging light should remain on for about 1 hour during charging,
thereafter the green light comes back on and the battery cartridge may
be removed and used.
5. After charging, switch off and unplug the charger from the power supply.
6. Remove the battery pack from the charger and slide it back into the
wrench until it clips into place. The battery pack should slide in easily. If the
battery pack is not to be fitted immediately, ensure that the metal
contacts are protected so as to avoid the possibility of a short circuit
which would cause damage.
7. For maximum battery life, we recommend that you maintain the battery
in a fully charged state at all times.
•
Remember to avoid extremes of heat or cold when charging. Avoid
temperatures outside the range of Minimum 4°C /Maximum 50°C.
Avoid
placing batteries in direct strong sunlight or other heat source.
NOTE: Ni-Cad batteries as used in Clarke cordless power tools should
be given a full charge when first supplied new. Maximum battery
performance will be achieved after approximately 5 complete
charge/discharge cycles.
Содержание CIR220
Страница 16: ......
