background image

3

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

COMMON BEND

(Shown aligned for 90

o

 bend)

For common bending, open arms of tubing bender to position shown above. 
Insert tubing into correct size channel. Align “0” mark on roll guide with “0” 
mark on bending die. For a 90 deg bend, align the BEND  mark made earlier 
with the “L” line on roll guide (for other angles less than 90deg, BEND mark 
must be adjusted to a different alignment on roll guide - see Fig 3B. 

Note that the reference mark is below the tubing bender. Holding both 
handles of the tubing bender, draw them together with a slow, steady motion 
to create the bend. The bend is complete when the “0” mark on the roll guide 
is aligned with the desired angle mark on the bending die. Release the 
handles. The tubing may naturally try to spring back against the bend, 
resulting in an angle less than intended. Check the bend on an angle 
template or protractor to verify.

Отзывы: