7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Wiring up these models should be
carried out as follows:
1. Remove the cable gland and
rubber washer from the cable
inlet and retain. Fig. 2 shows the
gland and washer removed from
model 150D.
2. Remove the Terminal Box cover
by unscrewing the four securing
screws.
3. Remove the screws securing the
cable clamp.
4. Thread the cable gland, followed
by the rubber washer over the
cable, then thread the cable
through the cable inlet.
5. Carefully strip the outer insulation
from the conductors for a
distance of approx. 30mm taking
care not to damage the
conductor insulation.
6. Strip the conductor insulation, for a distance of approx. 8mm and twist the
strands together, on each conductor.
7. Identify the terminals by observing
the embossed symbols on the
base of the junction box, and
indicated in Fig.4.
These are L - Live, N - Neutral and
earth.
Connect the conductors
accordingly.
NOTE:
The cable path for the 500SD
is shown by the dotted line in
Fig. 3.
8. Replace the cable clamp ensuring it firmly clamps the OUTER insulation, or
sheathing, and NOT the conductors.
9. Push the rubber washer into the cable inlet and screw in the cable gland
firmly. Do not overtighten as this could strip the plastic threads.
10. Before replacing the cover, ensure the terminal black is located snugly on
the locating pegs, illustrated in Figs. 3 and 4.
Содержание CHL1000TD
Страница 12: ......
