Clarke CEW1000, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 20

10
MAINTENANCE
CLEANING
• Always inspect the tool before use, and ensure it is in top condition.
• Ensure all air vents are clear, (use compressed air to clean the
machine if possible).
GENERAL MAINTENANCE
• Ensure all nuts, bolts and screws remain tight to ensure the machine
is in safe working condition.
• Refer to your CLARKE dealer if internal maintenance is required.
• Check the power cable to ensure it is sound and free from cracks,
bare wires etc. avoid using solvents when cleaning plastic parts,
most plastics are susceptible to damage from the various types of
commercial solvents.
• All bearings etc, in this tool are lubricated with a sufficient amount
of high grade lubricant for the tools lifetime under normal operat-
ing conditions, therefore no further lubrication is required.
REPLACING THE CARBON BRUSHES
Remove and inspect the carbon
brushes after periods of extended use.
Replace them when they eventually
wear down. The brushes should be kept
clean and free to slide up and down in
the holders. Both brushes should be
replaced at the same time as a pair.
Only use identical brushes from your
Clarke dealer.
Use a screwdriver to remove the brush
holder covers from the machine body.
Draw out the worn brushes and insert
new ones before replacing the brush
holder caps.