8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE STAPLER/NAILER
1.
P
ay attention to all of the safety warnings in these operating instructions.
2. Set the ON/OFF switch to the ON
position.
3. Press the stapler/nailer against the
work and pull the trigger.
• Always hold the stapler/nailer
square to the workpiece, never
at an angle.
4. Release the trigger and lift the
stapler/nailer away from the
workpiece.
5. Repeat steps 3-4 as required.
6. In the event of long breaks in work or at the end of the working shift:-
• Switch off the stapler/nailer,
• Remove the mains plug from the power supply,
• Empty the magazine.
TIPS
• Do not intentionally activate the stapler/nailer if the magazine is
empty.
• Do not attempt to staple/nail at the edge of a workpiece, the edge
could fail, causing a nail or staple to shoot straight through.
TO CLEAR A JAM
Do not pull the trigger until the jam has been cleared, as this could cause
serious damage:
1. Release the magazine catch and slide the magazine open.
2. Remove all staples/nails from the chamber.
3. Using pliers, grip the jammed fastener and pull firmly to dislodge it.
4. Once the jammed fastener is removed, reload and continue.
WARNING: SWITCH OFF THE STAPLER/NAILER AND REMOVE THE PLUG
FROM THE MAINS SUPPLY BEFORE CLEARING A JAM.
