9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADJUSTING THE DEPTH OF CUT
1. Rotate the depth adjustment
knob until the indicator arrow
aligns with the desired cutting
depth on the depth gauge.
• The minimum cutting increment
is 0.2 mm.
• The maximum cutting depth of
the planer is 1.5 mm.
NOTE:
For optimum planing performance, the maximum cutting depth is
0.4 mm per pass. Make multiple cuts, removing less than 0.4 mm
with each pass to achieve the total cutting depth.
GRAIN DIRECTION
The planer must always cut in the
same direction as the grain of the
wood.
There are six sides to every board:
two face grains, two side/edge
grains, and two end grains.
When planing the face and side/
edge grain, always plane in the
direction of the grain.
CAUTION: ALWAYS ENSURE THAT THE NUMBER ON THE DEPTH GAUGE IS
AT THE “0” POSITION WHEN THE PLANER IS NOT IN USE. HOWEVER, EVEN
AT “0”, A SLIGHTLY PROTRUSIVE BLADE COULD STILL MAKE CONTACT
DEPENDING ON HOW THE BLADE WAS INSTALLED. ENGAGE THE SAFETY
KICKSTAND TO PREVENT THE BLADE FROM TOUCHING THE WORKBENCH.
WARNING: DO NOT PLANE
ACROSS THE GRAIN OF THE
WOOD. DO NOT PLANE END
GRAIN AS THE WOOD WILL
SPLINTER.
Содержание CEP450
Страница 20: ......
