Clarke CCM125C, Инструкции по сборке и техническому обслуживанию

Страница: 11 / 16

11
edge of the motor support plate as
shown
in fig 8, to ensure the motor is
square to the support and frame. Secure
the motor in this position by fully
tightening the four mounting bolt/nuts.
• This adjustment ensures that the two
pulleys are in alignment and it is
important that time is taken to ensure it is
correct, otherwise premature failure of
the drive belt could occur.
6. Slacken the two nuts, previously nipped
up, which secure the motor mounting
plate to the frame, then push down on the motor so that tension is applied
to the belt. The tension is correct when there is approximately ½"
movement at the centre of the belt when using moderate thumb
pressure. When satisfied, secure the motor support plate by evenly
tightening the nuts behind the securing plate.
NOTE: It is important that the belt tension and pulley alignment are
correct, to ensure satisfactory operation of the machine and to
prevent excessive wear and premature failure of the drive belt.
7. To attach the outer cover to the inner cover it is first necessary to attach
the support chain, using the cross headed screws attached with washers
and nuts, to the holes provided in the inner and outer cover. The outer
cover is then secured to the inner cover using similar cross headed screws
with nuts and washers.
NOTE: The chain is a safety feature to prevent undue strain on the power
cable when the outer cover is removed, and it is important that it
is attached at all times.
DRUM COLLAR
NOTE: The drum collar is a safety feature, and must ALWAYS be in place.
DO NOT operate the machine with the collar removed.
1. Before the collar is attached, it is recommended that a layer of grease
(not supplied) is applied to the drive teeth under of the rim of the drum.
2. Attach the drum collar as shown in Fig 9. The two halves must bolted
together using three M6 x 20mm
bolts with a flat washer, spring
washer and nut, and each half is
secured to a bracket at either
side with a single M6 x 10mm
bolt with a flat and spring
washer. (Bolts may be supplied
already fitted to the collar).
Fig. 8
Fig. 9