Clarke CCM125C, Инструкции по сборке и техническому обслуживанию

Страница: 8 / 16

8
Fig. 5
3. Slide the circular locking plate (D), over
the large diameter shaft, at the leg end of
the frame, with the rim facing inwards, as
shown in Fig.4. (Note that the centre hole
in the plate is cut away to allow the plate
to pass over the circlip on the shaft).
Secure with two M8 x 25 bolts, each with a
nut, flat washer and spring washer.
THE HANDWHEEL
1. Insert the spring into its holder in the centre
of the wheel spar. Hold it in place, and
slide the handwheel over the shaft so that
the shaft retains the spring, and the holes
in the bracket Y, (Fig 4), line up with the
drilled hole in the shaft.
2. Insert the M10 x 65mm bolt with flat
washer at the bolt head, and screw on
two nuts. Screw the first nut up against the bracket firmly, but not so tightly
so as to prevent the handwheel from pivoting about the bolt. Lock the
nut in this position by screwing up the second nut tightly.
NOTE: The handwheel must be allowed to pivot about the bolt so that
the lugs on the bracket (Y) can be engaged or disengaged from
the slots in the locking plate.
THE MIXING BLADES
1. Bolt the mixing blades in place loosely as
shown in Fig 5.
• Two holes are provided at the base of
the drum into which an M8 x 20 bolt may
be inserted from the inside the drum.
These bolts are supplied attached to the
blades and are provided with a flat and
leather washer. The leather washer
should contact the drum.
2. A spring washer and a nut should be
threaded on loosely onto the bolt from
the outside. Do not tighten these yet.
THE UPPER DRUM
1. Position the rubber sealing ring on to the rim of the lower drum, ensuring
the holes in the seal and those of the drum line up.
2. Push an M6 x 16 cross headed screw through the rim from below and twist
through the corresponding hole in the sealing ring.
• The screws will hold the sealing ring loosely in position and not drop out.
Fig. 4