Clarke CBG6RL, Инструкция по эксплуатации и техническому обслуживанию

Страница: 6 / 11

PRE-ASSEMBLY CHECK
Before assembling your Bench Grinder, please check to ensure that all the parts
listed below have been included. If any parts are missing or damaged, you should
immediately contact your local dealer or CLARKE International on 0181-558 6696
for replacement.
1 . Main Body (switch and
power cable with plug are
included. Additionally, the
CBG6RL and 8RL models
include a lamp assembly
complete with bulb).
2. Two Eyeshields, each
complete with 1 x nut, 1 x
bolt, 1 x spring washer and
2 x flat washers (A).
3. Two spark arrestor
brackets, each complete
with 1 x screw, 1 x spring
washer and 1 x flat washer
(B).
4. Two Tool rests, each
complete with 2 x screws,
2 x spring washers and 2 x
flat washers (C).
5
ASSEMBLY
1. Attach the tool rests with the bolts and washers provided, in the manner
shown in fig 1 - page 6.
The tool rests are adjustable and should be positioned 1/16" (1.6mm) from the
grinding wheels, ensuring they are firmly fixed and horizontal.
NOTE: Tool rests are not used with the Wire Wheels fitted to the CBG6RWC and
8RWC models, but are available as an accessory. (See your CLARKE dealer).
2. Assemble the Spark Arrester Brackets on to the Wheel Guards, using the single
screw and washers provided, in the manner shown in fig. 2 - page 6.
NOTE: Before fully tightening the screw, each bracket should be adjusted by sliding
it as close as possible to the grinding wheel without impairing the wheels