Clarke CAT79, Инструкция по эксплуатации и обслуживанию

Страница: 9 / 16

9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
OPERATION
OPERATING THE IMPACT WRENCH
1. Locate the socket over the nut to
be tightened or loosened.
2. Squeeze the trigger to start the
wrench.
3. Release the trigger switch to stop
the wrench.
• The anvil will continue to rotate
very briefly after the trigger has
been released.
ADJUSTING THE POWER
1. To adjust the power, set the air
regulator to one of the 5 settings
available.(Setting 1-Low, 5 -High)
If you start by turning the regulator to
its lowest setting and applying the
wrench to a nut of known tightness (or
torque setting), you can then
gradually turn the regulator until the
nut or bolt moves very slightly in the
direction in which it was set. The
wrench is now set to replicate that tightness. Note the setting for future use.
When critical torque values are not required, tighten the nut or bolt until
secure, then turn a further quarter to a half turn, assuming no gaskets are
being used between surfaces. For additional power on disassembly work, turn
the regulator to its highest setting.
DISCONNECTING THE AIR SUPPLY
Do not disconnect the air supply hose until the compressor has been shut
down and the compressed air released.
1. Refer to the compressor instruction manual for the procedure to shut down
and release the compressed air.
2. Once the pressure has been released, disconnect the air supply hose from
the impact wrench.
Store the wrench safely in its box in a dry, secure environment.