Clarke CAT79, Инструкция по эксплуатации и обслуживанию

Страница: 10 / 16

10
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MAINTENANCE
DAILY
• Before use, drain water from the air tank, air line and compressor.
• Pour a few drops of CLARKE airline oil, into the air inlet. This should be
carried out regardless of whether or not an in-line mini oiler is used. If
an inline mini oiler is not used, this procedure should be repeated
after every two to three hours of use.
WEEKLY
• Check the air inlet screen filter
for blockage and clean if
necessary.
MONTHLY (IF IN CONSTANT USE)
• Grease the clutch mechanism
once a month if in constant
use, by removing the hammer
case (item 38) and applying 3/
4oz (22ml) of good quality
bearing grease. Ensure that the
screws connecting the hammer case are tightly secured.
CLEANING
• Keep the body of the impact wrench clean and free from debris.
Grit or gum deposits in the tool may reduce efficiency.
SERVICE AND REPAIR
If the tool runs erratically or becomes inefficient although the air supply is in
good order, it may be necessary to dismantle the air motor and impacting
clutch and replace any worn or damaged parts. Such servicing and repair
work should be carried out by qualified service technicians.
PERFORMANCE
Please note that factors other than the tool may effect its operation and
efficiency such as reduced compressor output, excessive drain on the airline
WARNING: MAKE SURE THAT THE IMPACT WRENCH IS DISCONNECTED
FROM THE AIR SUPPLY BEFORE STARTING ANY CLEANING, OR
MAINTENANCE PROCEDURES.