Clarke Arc/Tig135, Инструкция по эксплуатации и обслуживанию

Страница: 14 / 28

14
PREPARATION OF THE WELDING AREA
The working area must be sufficiently spacious, not humid, and well-ventilated as to avoid any
fumes which develop from the welding process and from incidental material adhering to the
pieces to be welded (oils, paints, tars...) which may cause annoyance to the operator.
Avoid welding by contact with humid parts nearby combustible liquids. Least of all, do not weld
upon tanks which may contain inflammable residuals.
SAFETY EQUIPMENT
A comprehensive range of CLARKE safety equipment for use when welding is available from
your local CLARKE dealer.
ELECTRICAL CONNECTIONS
WARNING! THIS APPLIANCE MUST BE EARTHED.
Connect the mains lead, through a suitably fused isolator switch, to a 230 Volt (50Hz) electrical
supply, with a fuse rating of 32amps.
A standard domestic 13 Amp plug MUST NOT be used with this welder.
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow .......... Earth
Blue .......... Neutral
Brown .......... Live
As the colours of the flexible cord of this appliance may not correspond with the coloured markings
identifying terminals in your plug, proceed as follows:
• Connect GREEN & YELLOW cord to plug terminal marked with a letter “E” or Earth symbol
“ ”, or coloured GREEN or GREEN & YELLOW.
• Connect BROWN cord to plug terminal marked letter “L” or coloured RED.
• Connect BLUE cord to plug terminal marked letter “N” or coloured BLACK.
Extension Cables
If an extension cable is fitted, ensure the minimum cross section of the conductor is 1.5mm
2
for
up to 15 metres in length, and 2.5mm 2 for up to 25 metres.