Clarke 7623300, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 12

10
USING THE AXLE STANDS
1. Refer to the vehicle handbook for
the correct jacking procedure and
location of the support points.
2. Fully spread the three legs.
ADJUST THE AXLE STAND
1. Remove the locating pin (if fitted).
2. Raise the upper column to the
required height and fit the locating
pin into the lowest hole visible.
3. Insert the retaining pin into the end
of the locating pin to secure it.
4. Position the axle stand under a
suitable supporting point. See your
vehicle manual for the location.
LOWERING THE VEHICLE
1. Slowly lower the vehicle onto the
centre of the saddle.
REMOVING THE AXLE STANDS
1. Raise the vehicle and remove the stands. Ensure that all tools, equipment
and personnel are clear before carefully lowering the vehicle to the
ground.
WARNING: BEFORE USE, MAKE SURE THAT THERE IS NO DAMAGE TO ANY
PART OF THE AXLE STAND. IF ANY FOUND, DO NOT USE.
WARNING: ENSURE THAT THE VEHICLE/LOAD IS CAREFULLY LOCATED ON
THE CENTRE OF THE SADDLE. FAILURE TO DO THIS CAN RESULT IN DAMAGE
TO THE AXLE STANDS, LOSS OF SUPPORT TO THE LOAD, SERIOUS
PERSONAL INJURY OR LOSS OF LIFE.