Clarke 7623300, Инструкция по эксплуатации и техническому обслуживанию

Страница: 6 / 12

6
MAINTENANCE
CHECKING/MAINTAINING THE OIL LEVEL
1. Ensure the jack is fully lowered by
turning the control valve fully anti-
clockwise.
2. Remove the filler plug.
• The oil should be almost level
with the bottom of the filler hole
• Oil can be topped up using
CLARKE Hydraulic Oil (p/n
3050830 1 litre).
3. Bleed any air from the jack as described below and replace the filler plug
and cover plate.
Dispose of old/spilled oil appropriately and wipe up any spillage.
BLEEDING AIR FROM THE SYSTEM
1. Use the operating lever to turn the release valve anti-clockwise, relieving
pressure inside the jack.
2. Pump the operating lever several times to purge air from the jack.
3. Turn the release valve clockwise and test the jack. If efficiency is still low,
check the oil level as described above.
STORAGE
1. Store in the blow-moulded case with the ram fully retracted, where it
cannot be damaged by moisture. If stored for long periods, clean any
grime from the piston area before use.
ENVIRONMENTAL PROTECTION
One of the most damaging sources of environmental pollution is oil products.
Never throw away used hydraulic oil with domestic refuse or flush it down a
sink or drain. Collect any hydraulic oil in a leak proof container and take it to
your local waste disposal site.
If disposing of this product or any damaged components, do not dispose of
with general waste. This product contains valuable raw materials and should
be taken to your local civic amenity site for recycling of metal products.