Clarke 7617000, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 16

9
5. Aim the pushing end towards the damaged area and slowly apply
pressure with the pump.
6. Once contact is established at each end, keep as well clear as practical
and slowly apply pressure to the damaged area until the desired
correction has been made.
CAUTION: KEEP HANDS AWAY FROM CONTACT AREAS AND TIGHT
SPACES IN CASE THE COMPONENTS SHOULD SLIP AND CAUSE INJURY.
7. When the damaged area has been bent to the desired position, slowly turn
the release valve on the pump unit in a counterclockwise direction to
release hydraulic pressure before removing the Ram.
USING THE SPREADER WEDGE
1. Determine in which direction the metal needs to be spread.
2. Remove any obstructions that are in the way and could be damaged.
3. Place the Spreader Wedge so that the hinged arm is resting against the
part to be moved and the stationary base is bearing against a rigid
support. Hold the Spreader Ram in position and apply the pump pressure.
4. Once contact is established at each end, keep as well clear as practical
and slowly apply pressure to the damaged area until the desired
correction has been made.
CAUTION: KEEP HANDS AWAY FROM CONTACT AREAS AND TIGHT
SPACES IN CASE THE COMPONENTS SHOULD SLIP AND CAUSE INJURY.
5. When the damaged area has been bent to the desired position, slowly turn
the release valve on the pump in a counterclockwise direction to release
hydraulic pressure before removing the wedge.