Clarke 7333220, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 20

9
USING YOUR POWER WASHER
1. Turn the water supply on, making sure that the tap is fully open.
2. Plug the mains power cable into the electricity supply.
3.
LOCK
UNLOCK
Release the trigger lock.
4. Press the section of the On/Off
switch marked “I”.
• The pressure washer is now
ready for use.
5. Pull the trigger on the gun to start
water flow.
• Stand on a stable surface and
grip gun/lance firmly with both
hands.
• Expect the gun to kick back when the trigger is pulled.
6. Release trigger to stop water flow.
• The power washer will automatically go into bypass mode.
Bypass mode
: In bypass mode, the pump recirculates the water because
the trigger of the spray gun is not being pulled.
WARNING: FAILURE TO TURN ON THE WATER COULD CAUSE DAMAGE TO
THE PRESSURE WASHER.
WARNING: DO NOT ALLOW UNIT TO OPERATE IN BYPASS MODE FOR
MORE THAN TWO MINUTES AT ANY TIME. OVERHEATING OF PUMP CAN
CAUSE DAMAGE TO THE PRESSURE WASHER.