Clarke 7333220, Инструкция по эксплуатации и техническому обслуживанию

Страница: 14 / 20

14
TROUBLESHOOTING
If the following does not solve your problem, please contact the CLARKE service
department. See page 2
FAULT CAUSE SOLUTION
Pressure drop. Air in system. Bleed system by quickly operating trigger
several times. If necessary operate the
machine briefly without the high pressure
hose connected.
Worn high pressure
nozzle. Renew nozzle.
Pressure
fluctuations or
pressure drop. Shortage of water. Turn water tap on fully.
Water supply hose too
long/too narrow. Use a 1/2” diameter water supply hose.
No water due to
clogged inlet filter. Clean water inlet filter.
Oil leak. Worn seals. Contact your Clarke dealer.
Motor does not
start when
switched on. Plug is not connected
properly. Check plug and lead and have them
replaced by a qualified electrician if
necessary.
Mains fuse tripped/
blown. Renew fuse or reset.
Motor hums
when trigger
operated and
does not start. Mains voltage too low. Have electrical connection checked.
Incorrect diameter cable
resulting in voltage drop. Use correct diameter cable.
Pump seals stuck. Contact your Clarke dealer.
Motor cuts out -
trigger open. Motor protection switch
has been activated due
to overheating or motor
overload. Ensure supply voltage and unit voltage
are equal. Switch off and allow to cool for
at least three minutes.
Nozzle partly clogged. Clean using the supplied nozzle cleaning
needle.
Additives are not
being supplied. Additive container
empty. Fill additive container.
Lance not correctly set. Put lance on low pressure setting.
.