19
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
When not in use, store the push stick
in its holder on the side of the
machine.
Replace a damaged push stick
immediately.
MITRE CUTS
1. Slide the mitre gauge into the
groove in the table.
2. Adjust the mitre gauge to the
required angle.
3. Press the workpiece firmly against
the mitre gauge.
4. Switch on the saw.
5. Push the mitre gauge and the
workpiece toward the blade to
make the cut.
IMPORTANT: Always hold the guided part of the workpiece. Never hold the
part which is to be cut off.
6. Push the mitre gauge forward until the workpiece is cut all the way
through.
7. Switch off and do not remove the offcut until the blade has stopped.
BEVEL CUTS
Bevel cuts must always be made using the parallel fence.
1. Undo the bevel lock handle and
set the saw to the desired angle
on the scale.
2. Tighten the bevel handle to lock
the blade at the selected angle.
3. Set the parallel fence.
4. Perform the cut as you would for
a ripping cut.
NOTE:
If precision is required, use a
protractor between the blade and table.
Содержание 6500752
Страница 28: ......
