8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SETUP
AUXILIARY HANDLE & DEPTH STOP
NOTE:
The depth stop can only be used if the handle is installed.
1. Loosen the auxiliary handle by
rotating the shaft of the auxiliary
handle anticlockwise
2. Slide the auxiliary handle
assembly over the chuck and
onto the body of the drill.
3. Insert the depth stop rod into the
holder in the auxiliary handle
assembly.
4. Secure the handle in position by
rotating the shaft of the auxiliary handle clockwise.
• DO NOT overtighten.
ADJUSTING THE DEPTH STOP
To set the depth stop, loosen the handle by turning the auxiliary handle
anticlockwise and slide the rod to the required position.
• The scale markings on the rod are for reference only.
INSERTING AND REMOVING SDS BITS
This machine uses SDS+ bits and chisels
1. Wipe clean the bit shank.
2. Pull back the locking sleeve and
insert the SDS+ bit.
3. Release the locking sleeve.
4. Pull on the bit to check if it is
properly locked.
• The hammering function
requires the bit to be able to
move axially when locked in the tool holder.
WARNING: TO REDUCE THE RISK OF PERSONAL INJURY, TURN THE UNIT OFF
AND DISCONNECT IT FROM THE MAINS SUPPLY BEFORE INSTALLING AND
REMOVING ACCESSORIES
