Clarke 6471150, Инструкция по эксплуатации и обслуживанию, Страница: 11 / 16

11
USING YOUR DUST COLLECTOR
OPERATION
DO NOT OPERATE WITHOUT ALL PARTS IN PLACE!
Do not attempt to clean, remove/attach dust bags or carry out any servicing
to the unit whilst it is in operation, ALWAYS ensure it is switched off and isolated
from the mains by removing the plug from the socket.
CAUTION : THE BLOWER HOUSING CONTAINS A HIGH SPEED FAN
BLADE THAT COULD AMPUTATE FINGERS, GRAB LOOSE CLOTHING AND
NECKTIES ETC, AND PROPEL DUST AT VERY HIGH VELOCITIES.
A suitable length of flexible hose can be fitted to the collector inlet using the
3-way adapter supplied, (item No 29 in the parts list on page 13). The collec-
tor can also be connected directly to the woodworking machine being used,
using the appropriate hose and adapters which can be purchased sepa-
rately from your nearest Clarke dealer.
To switch ON, press the switch cover (see fig
10) down and slide in direction of arrow and
lift up, this will expose the ON/OFF buttons,
(see fig 11 ) Push the ON button, (green
button ‘I’). DO NOT close the cover as this will
switch the machine OFF again.
NOTE: In case of emergency, close the
switch cover quickly, cover will
latch down and motor will be
switched OFF. To switch OFF nor-
mally, press OFF button, (red button
‘O’), always close cover to prevent
accidental starting.
MAINTENANCE
Always inspect the machine before use, and ensure it is in top condition.
Excessive dust in the motor can cause overheating, ensure all air vents are
clear, to avoid eye injury or adverse reaction to dust, clean the machine by
blowing out the air vents using low pressure compressed air where possible.
Check the power cable to ensure it is sound and free from cracks, bare wires
etc. Avoid using solvents when cleaning plastic parts, most plastics are
susceptible to damage from the various types of commercial solvents.
Fig. 10
Fig. 11