Clarke 6470144, Инструкция по эксплуатации и обслуживанию, Страница: 7 / 20

7
Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com
17. Do not use the angle grinder without the disc guard. Make sure that the
guard is securely fitted before operating the angle grinder.
18. Always hold the angle grinder with both hands. Ensure that the workpiece
is kept at waist height where possible. Never use the angle grinder
between the legs whilst sitting on the floor.
19. For cutting, always feed the disc into the work so that an upcutting action
is achieved.
20. Do not allow bystanders (children or adults) to be nearby when using an
angle grinder.
DISC SAFETY INSTRUCTIONS
1. Check the speed of the disc before fitting. Never use a disc with a rated
speed less than the no load speed of your angle grinder and only use
discs that comply with EN12413. See Specifications on page 16. Check
that the speed marked on the wheel dimensions is compatible with the
grinder. Check that discs are specifically for hand held angle grinder use.
2. Inspect the disc carefully before use. Never use a disc that is chipped,
cracked or damaged. Fragments from a broken or damaged disc can
cause serious injury. Ensure defective discs are destroyed and not used.
3. Bonded abrasive products are breakable and must therefore be handled
with utmost care. The use of damaged or improperly mounted or used
abrasive products is dangerous and can cause serious injuries.
4. Always refer to the label for specified usage and observe the safety
information. Do not use for purposes other than specified. Discs for wet
cutting applications must not be used with this angle grinder.
5. Always use the correct disc for it’s intended task. Using the incorrect disc
can cause serious injury.
6. Allow the disc and tool to do the work. Never force the disc onto the
workpiece as this could cause kickback and/or shatter the disc causing
serious injury. Kickback can occur in the event of a disc jam.
7. Do not use cutting discs for side grinding. Do not put sideways pressure on
cutting discs.
8. Do not use separate reducing bushes or adapters to adapt large hole
abrasive wheels. Do not force a disc onto a machine or alter the size of
the arbor hole
.
9. Abrasive products shall be handled and transported with care. Abrasive
products shall be stored in such a manner that they are not subjected to
mechanical damage and harmful environmental influences. It is
recommended that discs are stored in the case provided to protect them
from damage and hazardous material.
Please keep these instructions in a safe place for future reference.