12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
Always inspect the jump-start before use to ensure the cables are in good
condition and the clamps are clean and free from corrosion. If damaged they
should be replaced.
Keep the unit clean by wiping with a dry cloth. DO NOT use solvents as a
cleaning agent.
GENERAL CARE
Keep the unit at HIGH or FULL CHARGE status at all times.
Always turn the jump-start OFF during storage and store in an upright position,
away from direct sunlight, moisture or sources of extreme heat or cold.
NEVER attempt any repair unless your are a qualified technician. If you have a
problem with the machine contact your local CLARKE dealer.
Your CLARKE jump-start has been designed to give long and trouble free
service. If, however, having followed the instructions in this booklet carefully,
you encounter problems, take the unit to your local CLARKE dealer.
REPLACING THE BATTERY
1. Unscrew and remove the self tapping screws securing the back cover. Lift
off the cover to expose the battery and other components.
2. Lift out the battery from the battery compartment, and detach the heavy
duty, and other cables, from the battery terminals.
3. Taking great care not to short across the battery terminals, connect the
RED heavy duty cable, and other cable with red sheath, to the battery
terminal painted RED, and the black cables to the other battery terminal.
4. Gently slide the new battery into position in its compartment, taking care
not to damage the printed circuit board
5. Replace the back cover and secure with the self tapping screws.
CHANGING THE LIGHT BULB
1. Gently squeeze the sides of the lens bezel together, or very carefully use a
screwdriver to disengage the clips at either side, and pull the lens and
bezel out.
2. Unscrew and remove the burned out bulb and screw in a replacement.
3. Snap the lens and bezel back into place and replace the back cover.
Содержание 6240030
Страница 16: ......
