7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
LED LIGHT
The power pack has an LED light that has 3 settings and can be used as a
torch or safety lighting as follows.
1. Press and hold the power switch for 3 seconds to turn on the torch setting.
2. Press the power switch again to turn on the LED flashing strobe effect
lighting.
3. Press the power switch for a third time to turn on the LED SOS flashing effect
lighting.
4. Press the power switch for a fourth time to turn the LED light off.
CHARGING MOBILE PRODUCTS
1. Choose the appropriate mobile charging adaptor on the charging cable,
Lightning, Micro USB or USB-C type, and connect to the device to be
charged.
2. Insert the USB end of the charging lead into the USB output charging port
on the power pack.
3. Press the power switch for charging to begin.
NOTE:
The blue indicator lights will keep bright when charging. If the
device doesn’t start charging after 3 seconds the indicator lights
and device will turn off.
JUMP STARTING A 12V CAR (PETROL ONLY)
ALWAYS
carry out the following preliminary checks before connecting the
jump starter to the car battery:
• Ensure the vehicle ignition and ALL ancillary equipment - lighting,
radio etc, are switched off.
WARNING: FAILURE TO FOLLOW THE INSTRUCTIONS BELOW AND THE
SAFETY INSTRUCTIONS ON PAGE 6 MAY RESULT IN PERSONAL INJURY,
DAMAGE TO THE VEHICLE, OR THE POSSIBILITY OF AN EXPLOSION
WARNING: IT IS POSSIBLE THAT SOME ELECTRONIC EQUIPMENT COULD BE
DAMAGED BY JUMP STARTING. ALWAYS CHECK WITH THE CAR
MANUFACTURER’S HANDBOOK TO DETERMINE WHAT PRECAUTIONS IF
ANY SHOULD BE TAKEN.