6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
1. Before inserting the output plug,
switch all three switches (G) to
OFF. Then switch the converter
ON, using the ON/OFF switch (A)
on the front panel.
In this condition the lamp (B) and
the rocker switch A will illuminate.
Check to ensure the ammeter (C) is
set to zero. If necessary, adjust
using the small adjustment screw
located at the bottom centre of
the ammeter so that it reads zero.
2. Switch OFF the converter and
connect the plug from the
motor to the output socket (E).
3. Using the three switches (G), set
the output so that it is equivalent
to the HP of the motor to be
driven. This value should be found on the motor data plate.
The chart below shows the switch settings for the required outputs.
4. With the switches set, and the output plugged in, switch ON the converter
and proceed to start the motor/machine. Note that indicator lamp (F) will
illuminate when the switches (G) are set.
DO NOT ADJUST THE SWITCHES (G) WHEN THE PHASE CONVERTER IS SWITCHED
ON.
Model PC20
Motor HP
SW 1
0.5HP
SW 2
0.5HP
SW3
1|HP
0.5
ON
OFF
OFF
0.5
OFF
ON
OFF
1
ON
ON
OFF
1
OFF
OFF
ON
1.5
ON
OFF
ON
1.5
OFF
ON
ON
2
ON
ON
ON
Содержание 6012785
Страница 1: ...USER INSTRUCTIONS ORIGINAL INSTRUCTIONS GC1220 PHASE CONVERTER MODEL NO PC20 PART NO 6012785...
Страница 12: ......
