Clarke 3400820, Инструкция по эксплуатации и обслуживанию

Страница: 7 / 16

o
3. The Hand Wheel & Fittings
3.1 Slide the Locking Plate (F), over the large diameter shaft, at the leg end of the frame, with
the rim facing inwards, as shown in Fig.4.
(Note that the hole in the Plate is ‘notched’. This is to allow the plate to slide over the lugs
of the circlip on the shaft).
Secure with two M8 x 25 bolts, each with a nut, flat and spring washer, ensuring nuts are
tight.
3.2 Insert the spring, into its holder in the Handwheel,
and holding it in place, slide the wheel over the large
diameter shaft so that the shaft retains the spring.
NOTE:
This operation may need a little exertion in order to compress the
spring sufficient to be able to slip the handwheel on to the shaft.
3.3 Line up the holes in the bracket (Y, Fig.. 4), with the
hole drilled in the shaft, then insert the M10 x 65mm
bolt with flat washer at the bolt head.
NOTE:
You will find it an easier task to line up the holes on one side of
bracket ‘Y’ only, to begin with. Enter the bolt, then use that as
a pivot, by pushing the handwheel IN to square it up, in order
to line up the holes on the other side. When the holes at the
opposite side are aligned, tap the bolt through GENTLY to avoid
damaging the threads.
3.4 Screw on two nuts. Screw the first nut up against the
bracket firmly, but not so tightly so as to prevent the
handwheel from pivoting about the bolt. Lock the
nut in this position by screwing up the second nut,
tightly so that it locks.
NOTE:
The handwheel must be allowed to pivot about the bolt so
that the lugs on the bracket (Y) can be engaged or disengaged
from the slots in the Locking Plate.
7
Fig..4
Fig.5
4. The Mixing Blades
4.1 Bolt the blades in place loosely as shown in Fig. 5.
It is IMPORTANT that the blades are orientated
exactly as shown. This ensures that the mix will be
thrown OUTWARDS when the drum turns
Two holes are provided at the base of the drum into
which a M6 x 20 bolt may be inserted from the
outside. These bolts are provided with a flat washer
and leather washers. The leather washer should bear
against the drum. A spring washer and a nut should
be threaded on loosely on the inside. Do not tighten
the nuts.