9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
• Let the tool do the work. The actual weight of the sander is normally
sufficient for efficient sanding. Do not put additional pressure on the
sander, which would only slow down the speed of the belt, reducing
efficiency and placing an additional burden on the motor.
4. Take care to keep the sander moving around at all times. Avoid dwelling in
one place for more than a moment.
5. When finished sanding, release the throttle lever and allow the motor to
stop before carefully putting the tool down.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air supply hose until the air supply has been shut
down and the compressed air released.
2. Refer to the compressor instruction manual for the procedure to shut down
and release the compressed air.
3. Once the pressure has been released, disconnect the air supply hose from
the sander.
MAINTENANCE
Please note that factors other than the tools condition may effect its operation
and efficiency, such as reduced compressor output, excessive drain on the
airline, moisture or restrictions in the airline, or the use of connectors of
improper size or poor condition which will reduce the air supply.
DAILY
1. Before use, drain water from the airline and compressor.
2. Lubricate the air tool daily for optimum performance. Use a high quality
airline oil either via a lubricator in the air supply system or by placing a few
drops into the air inlet immediately before use. This should be carried out
regardless of whether or not an in-line lubricator is used.
CLEANING & OVERHAUL
1. Keep the moving parts clean and free from debris.
2. If the sander becomes sluggish and the air supply is of good quality, it may
be necessary to replace worn or damaged parts.
WARNING: MAKE SURE THAT THE SANDER IS DISCONNECTED FROM THE
AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE
PROCEDURES.
Содержание 3120179
Страница 16: ......
