Clarke 3110863, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 16

10
OPERATING INSTRUCTIONS
INSERTING THE DRILL BIT
To insert a drill bit, proceed as follows.
1 Open the chuck jaws by inserting the chuck
key in one of the holes in the chuck and
turning it as shown.
2 Make sure that the head of the chuck key is
located on the cog barrel of the chuck.
3 Turn the chuck key until the chuck jaws are
open sufficiently to take the drill bit.
4 Place the drill bit in the jaws of the chuck as
far as it will go.
5 Close the chuck jaws and tighten to grip the
drill bit by turning the chuck key as shown.
6 Make sure that the chuck jaws are fully closed
and that the drill bit is firmly held.
To remove the bit, proceed as follows.
1 Open the jaws by inserting the chuck key in
one of the holes and turning it as shown.
2 Remove the drill bit.
WARNING: REMOVE THE CHUCK KEY BEFORE OPERATING THE DRILL.
Drill bit
Cog
barrel
Chuck
jaws
Close
jaws
Open
jaws
Chuck
key