Clarke 3082110, Инструкция по эксплуатации и техническому обслуживанию, Страница: 6 / 16

6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
SPECIFICATION
AIR SUPPLY
For best results, the air supply to the spray gun must be clean and dry, with no
oil or water contamination. Follow the air compressor manufacturer’s
guidelines on installation and operation to ensure that your air supply is as
clean as possible.
The compressed air supply line to the spray gun must be fitted with a filter
capable of removing any oil or water together with a suitable pressure
regulator.
Higher pressure and contaminated air will shorten the spray gun life due to
faster wear and could become a safety hazard.
Water in the air line will also cause damage and may contaminate the paint
being used. Therefore ensure the air supply is properly filtered.
Line pressure, or supply hose inside diameter, should be increased to
compensate for unusually long air hoses (over 10 m). Minimum hose diameter
should be 6mm (¼") ID, and fittings should have the same inside dimensions.
The air inlet used for connecting air supply has a standard ¼” BSP thread.
Container Volume 100 ml
Air Inlet Connection 1/4” BSP
Minimum Compressor Size 3 HP
Typical Operating Pressure 30-43 psi
Maximum Operating Pressure 43 psi
Paint Delivery 45 - 65 ml/min
Weight 373 g
Depth x Width x Height 245 x 125 x 65m
Air Consumption 8 cfm
Nozzle Size 0.8 mm