Clarke 3082110, Инструкция по эксплуатации и техническому обслуживанию, Страница: 10 / 16

10
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
To obtain the best results, keep your
spray gun level and parallel to the
surface at all times. Keep the nozzle
23 - 30 cm from the surface and spray
evenly from side to side or up and
down. Use your arm to control the
spray gun, not your wrist.
The gun should be perpendicular to
the surface being covered and
moved parallel with it. The stroke
should be started before the trigger is pulled and likewise released before the
stroke is ended. This gives accurate control of the gun and material.
Do not spray at an angle as this will
lead to paint runs on the surface.
Always use smooth and even strokes.
When spraying large areas, using a
criss-cross pattern as shown.
Never start or stop the spray gun
while it is aimed at the surface to be
sprayed. Evenly control the speed of
movement of the spray gun.
• Moving quickly over the
surface will give a thin coat
and slow movement will give a
heavy coat.
• Apply one coat at a time. If a further coat is required, make sure you
observe the manufacturers drying time recommendations before
applying a second coat.
• When spraying small areas, keep the output control on a low setting
as this will avoid using too much paint and prevent overspray.
• Where possible, avoid stopping and starting when spraying an
object. This can lead to too much, or not enough paint being
applied.