Clarke 195TEC, Инструкция по эксплуатации и обслуживанию

Страница: 16 / 32

17
Mig 195TEC - Mig 205TE
A. It is necessary to fit the torch hose
assembly (7) to the machine, but
before doing so you must first
measure the length of protrusion of
the liner (9) from the brass nut (10).
IMPORTANT:
This measurement should be a
maximum of 18mm and should
be carefully trimmed to this
length using a good pair of side
cutters, or similar, ensuring there
are no burrs or sharp edges which
may impede the progress of the
wire when fitted.
B. Having checked the protrusion of
the liner, and trimmed where
necessary remove the nut (1) and
ASSEMBLY
A. Attaching the Torch
the washer (2) from the end of the torch assembly (7). Carefully feed the hose
assembly through the hole in the front face of the welder (16), taking care to
feed the electrical connectors (11-14) through at the same time. Continue to
feed the hose assembly through the brass collar (5) in the bracket assembly
(4).
C. You will notice a large ring terminal (3) roughly in position to be threaded on
the end of the hose assembly, as it appears through the brass collar (5) in the
bracket assembly (4). Thread the terminal on the hose assembly, followed by
the washer (2) and screw on the nut (1) which should then be carefully
tightened.
Note: when correctly assembled, the wire liner (9) must not be in contact with the
wire feed roller (8)
.
D. Fit the plastic cover (15) over the complete assembly, securing with the two
self-tapping screws provided.
E. Connect the gas hose (12) to the gas hose nipple (6) securing with the worm
drive clip (13) provided.
F. Make the electrical connections by joining connectors (11-14)
Note: The connectors are one-way fit, and simply clip together - do not use
excessive force.
Fig.2