Clarion UNGO PRO SECURITY K20, Руководство по установке

Страница: 8 / 14

8
Valet/Program Switch, 2-Pin BLUE Plug
The Valet/Program button should be accessible from the driver’s seat. It plugs into the BLUE port on the side of the unit. Consider how the button
will be used before choosing a mounting location. Check for rear clearance before drilling a 9/32-inch hole and mounting the button.
System Features Learn Routine
The System Features Learn Routine dictates how the unit operates. It is possible to access and change any of the feature settings using the
Valet
®
/Program switch.
T Too eenntteerr tthhee lleeaarrnn rroouuttiinnee::
1. K Keeyy.. Turn the ignition on and then back off.
2. C Chhoooossee.. Within 10 seconds, press and release the Valet
®
/Program switch the number of times corresponding to the
feature number you want to program. (See Feature Menus.) Once the Valet
®
/Program switch has been pressed and
released the desired number of times, press it once more and hold it. After a second, the LED will flash and the horn
will honk (if connected) to indicate which feature you have accessed.
3. T Trraannssm miitt.. The transmitter is used to select the desired setting. As shipped, the unit is configured to the LED ON set-
tings. These are the default settings. Pressing the lock button will set it to the LED ON setting. The LED will light solid
(stop flashing) to indicate the setting. The horn will honk once (if connected). Pressing the unlock button will change
the setting to the LED OFF setting. The LED will go out indicating the change and the horn will honk twice (if con-
nected).
4. Release. The Valet
®
/Program switch can now be released.
For example, to program the arming mode from active to passive, within 10 seconds of turning the ignition off, and press and release the
Valet/Program switch once. Then press it again and hold it. The LED will flash in groups of one and the horn will honk once (if connected).
While holding the Valet
®
/Program switch, press the unlock button. The LED will stop flashing and go out. The horn will honk twice (if con-
nected). Passive arming is now programmed. If that was not the desired setting, without releasing the Valet
®
/Program switch, press the lock
button. The LED will light solid and the horn will honk once (if connected). Active arming is now programmed. Release the Valet
®
/Program
switch after the selection has been made.
You can advance from feature to feature by pressing and releasing the Valet
®
/Program switch the number of times necessary to get from the feature
you just programmed to the feature you wish to access. For example, if you just programmed Feature 2 and you next want to program Feature 3
to off, release the Valet
®
/Program switch. Press and release it once to advance from Feature 2 to Feature 3. Then press it once more and hold it.
The LED will flash in groups of three and the horn will honk three times (if connected) to confirm that you have accessed Feature 3.