3
II.
RUN WIRE HARNESS
A. Route wire harness behind the drivers seat.
B. Plug in Clarion”T” harness or hard wire pigtail harness in the
dash.
III.
INSTALL THE BRACKETS TO THE ENCLOSURE
A. Position enclosure upright.
B. Locate the two horizontal dimples on each side of the enclosure.
C. Screw in the attachment brackets through the dimples using the
(4) supplied pilot point wafer head screws.
IV.
TEST THE ENCLOSURE
A. Plug in the Clarion “T” harness or hardwire the pigtail harness
behind the radio.
B. Place the enclosure into the vehicle (correct position is on the
transmission hump).
C. Plug in the wire harness to the enclosure.
D. Adjust subwoofer gain (gain pod is located on the amplifier next
to the wire harness connector, and is adjustable with a Phillips
screw driver).
