Genelec 5050A
Home Theater Subwoofer
Operating Manual
5050A
Страница 1: ...Genelec 5050A Home Theater Subwoofer Operating Manual 5050A ...
Страница 2: ...hest response and only then use the controls to fine tune the balance and phase alignment between the subwoofer and the main loudspeakers Start by placing the subwoofer close to the center of the front wall however leaving at least 10 cm 4 of free space in front of the amplifier panel We recommend a distance of less than 60 cm 24 to the wall This posi tion gives increased acoustic loading and SPL ...
Страница 3: ...UTOSTART function which automatically turns the amplifier to STANDBY mode if an input signal has not been detected for approximately 30 minutes and back to ON mode when the signal returns The function can be deactivated by turning the AUTOSTART dip switch to OFF A two colour LED on the amplifier panel indicates the amplifier status green for ON and yellow for STANDBY Automatic protection circuits ...
Страница 4: ... 330 mm 13 If the subwoofer is flush mounted into a wall or a cabinet the recess must be 10 cm 4 wider higher and deeper than the subwoofer itself to allow sufficient clearance for the passive radiators and air circulation for cooling 5050A Amplifier short term output power Long term output power is limited by driver unit protection circuitry 70 W Amplifier system THD at nominal output 0 08 Mains ...