46
VRX630
English
Installation and Wire
connection manual
This unit is designed for fixed installation in the
dashboard.
If the vehicle is equipped with a factory-installed
radio, install the main unit with the parts and
screws marked (
∗
). (Figure 8)
If the vehicle is not equipped with a factory-in-
stalled radio, obtain an installation kit to install
the main unit in the following procedure.
1.
Remove the screws from both side of the
main unit. Then, at either side, lift the leaf
spring until the engaging claws are released
from the holes, and slide the spring to the
direction of arrow to remove it. Repeat the
■
Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)
same for the other side to remove the springs
from the both sides. (Figure 7)
2.
Secure the mounting brackets to the chassis
as shown in Figure 8. Holes are pre-tapped
for TOYOTA and NISSAN vehicles; modifica-
tion, such as drilling new holes, of the mount-
ing brackets may be required for other mod-
els.
3.
Wire as shown in Section 8.
4.
Secure the unit in the dashboard, and then
reassemble the dashboard and the centre
panel.
Note 1: In some cases, the centre panel may re-
quire some modification (trimming, filling,
etc.).
Note 2: If a hook on the installation bracket inter-
feres with the unit, bend and flatten it with a
nipper or a similar tool.
The parts and screws with this mark
are used to install radio or included in
the installation kit.
The screws with this mark are enclosed in
this set.
