English
16
NX502E
Cautions On Wiring
• Be sure to turn the power off before wiring. Be particularly careful where you route the wires.
• Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
• If the fuse should blow, check to see if the wiring is correct. If a fuse is blown, replace it with a
new one of the same speciication as the original.
• To replace the fuse, remove the old fuse of the power supply cord and insert the new one.
Note:
• There are various types of fuse holder. Do not let the battery side touch other metal parts.
Note:
*1 Some panel openings are too small for the unit depending on the vehicle type and model. In
such a case, trim the upper and lower sides of the panel frame by about 0.5 to 1.5 mm so the
unit can be inserted smoothly.
*2 If a hook on the installation bracket interferes with the unit, bend and flatten it with a nipper or
similar tool.
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modiication. (Trimming, illing, etc.)
Typical Mounting Brackets
In some cases the center panel may require modiication. (Trimming, illing, etc.)
Afix the screws to the marks.
• After the connection, ix the cord by a clamp or insulation tape for protection.
Fuse (15A FUSE)
Fuse holder
Example 1-3
Installation Guide
Интернет-магазин автозвука и автотоваров Винавто
winauto.ua
