English
Owner’s Manual
5
CM1624TB / CM1624TS
4. INSTALLATION
Bar Mount Installation
STEP 1:
Remove tower speakers and all the hardware
from the packaging.
STEP 2:
Using the supplied M6 Allen wrench, remove the
M6 bolts that hold the upper clamp onto the base
clamp of the tower speakers. Based upon the
diameter of the tower bar, select the inserts that
provides the best fit.
NOTE:
If using the 2.5” or 2.75” inserts, you will
need to use the M6 Hex Bolt (60mm) and remo
-
ve the default Mounting Spacer Inserts.
STEP 3:
Find a good location to run the wires and will not
impede movement of the tower speakers.
NOTE:
The tower speaker accommodates two different
types of speaker wire installation:
1. Going straight into a hole in the tower tube
thus the speaker wire will be routed through the
center hole of the rubber spacing insert. For this
installation type, please proceed to
STEP 4
.
2. Alongside the tube thus the speaker wire will
exit the rubber spacing insert through the side
notch. For this installation type, please proceed
to
STEP 6
.
STEP 4:
During the installation process, you should have
determined the best location to drill a hole into
the tower bar to run the speaker wires. If you
have, then please proceed to
STEP 5
.
If you have not, select a location that places the
tower speakers in an area that will have less
head contact and is equal on both sides.
Use tape to help determine the best mounting
locations.
Once you have selected the best locations, start
with drilling an 1/8” pilot hole into the tower bar.
The hole will be the center of the tower speaker
once mounted.
STEP 5:
Using a 1/2” drill bit, make the 1/8” pilot hole a
1/2” hole to allow a little adjustment when the
tower speakers are mounted. This will help in
the event of heavy vibration so the wires do not
get pinched.
Once the 1/2” hole has been drilled, please
de-burr the hole so there are not any sharp me-
tal edges that can damage the speaker wires. To
help prevent wire damage, please use a rubber
or plastic hole grommet.
M6 Allen
Wrench
Upper Clamp
Screws
Upper Clamp
2” Mounting
Spacer
Wiring (2’)
Tower Tube Wiring Detail
Wiring
Red (-)
Green (-)
Blue (-)
Black (+)
Black (-)
Red (+)
LED Wiring
Speaker Wiring
