English
Owner’s Manual
7
CM1624TB / CM1624TS
4. INSTALLATION
STEP 1:
Remove tower speakers and all the hardware
from the packaging.
STEP 2:
Using supplied M4 Allen wrench, loosen the
base clamp hex head shaft bolts on the left and
right side.
STEP 3:
Begin by pulling mount assembly out of base
clamp while feeding the cable through the mount
hole to create a gap between base and surface
mount parts.
STEP 4:
When adequate space is created, use the su
-
pplied M5 Allen wrench to loosen and remove
the bolts connecting the surface mount and bar
mount pieces.
STEP 5:
Once the bolts are removed, pull the bar mount
and assembly completely off of the wire.
STEP 6:
Find a good location to run the wires that will not
impede movement of the tower speakers.
NOTE:
The tower speaker accommodates two different
types of speaker wire installation:
1. Going straight into a hole in the surface thus
the speaker wire will be routed through the cen
-
ter hole of the rubber spacing insert. For this ins-
tallation type, please proceed to
STEP 7
.
2. Alongside the surface thus the speaker wire
will exit the rubber spacing insert through the
side notch. For this installation type, please pro-
ceed to
STEP 8
.
NOTE:
Blue Loctite is highly recommended when
installing the hex head bolts.
Surface Mount Installation
M4 Allen
Wrench
M5 Allen
Wrench
