Clarion CC520, Инструкция для владельца и по установке

Страница: 5 / 30

5
English
CC520
Before installation
• Before installing the camera or its
wiring, read all safety warnings and be
sure to install the unit correctly.
• Before installing the camera
permanently, use adhesive tape to
mount the camera in its proposed
position, then check the image in the
monitor to confirm proper display
before fixing the camera in its final
position.
5. INSTALLATION
• As far as possible, install on a day
with clear weather.
• Within the first 24 hours after
installation, do not expose the
installation to moisture (water, rain,
mist, snow, etc.), or subject
the installation to strong forces or
impacts.
• When installation must be performed
under conditions of low ambient
temperature (20°C or below), use a
hair dryer to warm the surface of the
bracket where the 2-side tape is to be
applied.
• Do not touch the bracket-mounting
surface’s 2-side tape, and do not
attempt to move or reset the tape after
initial application.
Notes:
• Before removing the protective paper
on the bracket, place it in the proposed
position on the vehicle and confirm
that the surfaces match properly
without gaps.
• When using screws to install the
bracket, use the right-left screw holes
provided on bracket A.
WARNING
■
Do not install on glass or body
surfaces treated with fluorinated
resins or other water-repellent
treatments.
■
Do not install within the sweep of
a rear window wiper, or near the
window washer’s nozzle.
■
Abide by the following rules in order
to prevent lowering of the installation
tape’s adhesion.
Precautions when using
double sided tape for installation
• Disconnect the battery’s negative (-)
terminal installing wiring.