clage GERMAN POOL GPIM7, Руководство по эксплуатации

Страница: 11 / 40

11
13. Purging
12. Functions of the LEDs
• Plastic surfaces and fittings should only be wiped with a damp cloth. Never use abrasive cleaners or
solvents.
• Clean the jet regulator or the hand-shower regularly and replace as necessary.
• Dirt and scale deposited in the pipes and heater will affect the function of the heater. Typical indications
of this are a reduced rate of flow or noisy flow. In such cases, have the heater inspected by a technician
and, if necessary, have the filter in the cold-water inlet cleaned.
To prevent damage to the appliance, the instantaneous water heater must be purged from air before
using it for the first time. Each time it is emptied (e.g. after work on the plumbing system, if there is a
risk of frost or following repair work), the appliance must be purged from air before it is used again.
1. Disconnect the appliance from the electrical supply.
2. Open and close the hot water tap until no more air emerges from the pipe and all air has been elimi
-
nated from the water heater.
3. Only then you should reconnect the power supply to the unit.
Green LED flashing regularly: Standby mode
Green LED lights: Appliance is heating water
Red LED lights: Maximum power reached; the desired outlet temperature cannot be
reached.
Red LED flash code:
long-short-short-short-long Inlet temperature too high
long- short-short-short-short Temperature sensor faulty
14. Maintenance and cleaning