Clack WS15P, Руководство по эксплуатации и ремонту

Страница: 13 / 20

WS15P Parts and Service Manual Page 13
Problem Possible Cause Solution
8. Hard or untreated water is being delivered
a. Bypass valve is open or faulty a. Fully close bypass valve or replace
b. Media is exhausted due to high water usage b. Check program settings or diagnostics for
abnormal water usage
c. Meter not registering c. Remove meter and check for rotation or
foreign material
d. Water quality fl uctuation d. Test water and adjust program values
accordingly
e. No regenerant or low level of regenerant in
regenerant tank
e. Add proper regenerant to tank
f. Control fails to draw in regenerant f. Refer to Trouble Shooting Guide number 12
g. Insuf fi cient regenerant level in regenerant tank g. Check re fi ll setting in programming. Check
re fi ll fl ow control for restrictions or debris
and clean or replace
h. Damaged seal/stack assembly h. Replace seal/stack assembly
i. Control valve body type and piston type mix
matched
i. Verify proper control valve body type and
piston type match
j. Fouled media bed j. Replace media bed
9. Control valve uses too much regenerant
a. Improper re fi ll setting a. Check re fi ll setting
b. Improper program settings b. Check program setting to make sure they are
speci fi c to the water quality and application
needs
c. Control valve regenerates frequently c. Check for leaking fi xtures that may be
exhausting capacity or system is undersized
10. Residual regenerant being delivered to service
a. Low water pressure a. Check incoming water pressure – water
pressure must remain at minimum of 25 psi
b. Incorrect injector size b. Replace injector with correct size for the
application
c. Restricted drain line c. Check drain line for restrictions or debris
and clean
11. Excessive water in regenerant tank
a. Improper program settings a. Check re fi ll setting
b. Plugged injector b. Remove injector and clean or replace
c. Drive cap assembly not tightened in properly c. Re-tighten the drive cap assembly
d. Damaged seal/ stack assembly d. Replace seal/ stack
e. Restricted or kinked drain line e. Check drain line for restrictions or debris
and or un-kink drain line
f. Plugged backwash fl ow controller f. Remove backwash fl ow controller and clean
or replace
g. Missing re fi ll fl ow controller g. Replace re fi ll fl ow controller
12. Control valve fails to draw in regenerant
a. Injector is plugged a. Remove injector and clean or replace
b. Faulty regenerant piston b. Replace regenerant piston
c. Regenerant line connection leak c. Inspect regenerant line for air leak
d. Drain line restriction or debris cause excess back
pressure
d. Inspect drain line and clean to correct
restriction
e. Drain line too long or too high e. Shorten length and or height
f. Low water pressure f. Check incoming water pressure – water
pressure must remain at minimum of 25 psi
13. Water running to drain
a. Power outage during regeneration a. Upon power being restored control will
fi nish the remaining regeneration time.
Reset time of day.
b. Damaged seal/ stack assembly b. Replace seal/ stack assembly
c. Piston assembly failure c. Replace piston assembly
d. Drive cap assembly not tightened in properly d. Re-tighten the drive cap assembly