GAS CONNECTION
Refit the burner tray into the firebox, fit the two
screws through the locating holes in the tray legs,
and tighten.
Purge the gas supply thoroughly to remove air and
dirt/debris BEFORE connection. Now disconnect
the inlet restrictor elbow from the inlet pipe.
Connect the previously installed gas supply to inlet
restrictor elbow, and re-fit the restrictor elbow to the
inlet pipe of the appliance.
If using an across hearth connection, ensure the
decorative fireframe and firefront will clear the sup-
ply route.
If the data/control plate is not already fitted, attach with two screws, ensuring the control knob is free to be
depressed fully.
FUEL BED LAYOUT
Coal EEffect O
Option
1. Remove the combustion matrix from its protective
packaging, and position onto the burner tray as
shown. The front edge of the matrix should sit snugly
behind the back edge of the burner rails. Do not fit the
matrix on top of the burner rails.
2. Next, remove the front coal strip from its protective
packaging and position as shown. The rear edge of the
front coal strip should fit in front of the burner rail.
Again, do not to place on top of the burner rails. When
the front coal is in position bend up the three metal
tags at the front of the tray to retain (inset).
8
11.2
12.0
Correct
Incorrect
