The SHoW DMX OEM Receiver User’s Manual
Rev 1.1 10/14/08
8 of 27 Pages
System Compliance Information
All SHoW DMX Products are RoHS Compliant
Safety Notices
Please read this entire manual before using your new equipment. Please keep the
manual in a safe place so you can refer to it in the future as required.
The SHoW DMX System is intended for use only by qualified professionals. Connection,
installation and hanging of this equipment must be performed in accordance with all
pertinent local, regional and national safety codes and regulations.
SHoW DMX equipment is intended for indoor use only unless specified for outdoor use.
Keep the equipment dry! Do not operate the equipment if it gets wet!
Do not operate in excessive heat/direct sunlight.
Be sure installation provides adequate ventilation. Some system components can
produce significant heat and must be properly installed to allow proper cooling and
assure user safety. All sides of the equipment must be clear of obstruction and allow
free airflow.
There are no user-serviceable parts inside! Refer to qualified service personnel!
RF Exposure:
The antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20cm from all persons and must not be collocated or
operating in conjunction with any other antenna or transmitter.
End-Use Compliance Certifications
City Theatrical # 5691 and 5692 Radios are fully compliant with the agency requirements
indicated by their certification markings when used in OEM applications, and are
approved for modular OEM use.
City Theatrical, Inc. # 5605 OEM Receivers are designed to meet North American safety
and emissions standards, however final compliance can only be confirmed after units
are correctly installed in the host hardware.
City Theatrical, Inc. # 5606 OEM Receivers are designed to meet North American and
CE safety and emissions standards, however final compliance can only be confirmed
after units are correctly installed in the host hardware.
OEM Applications of these City Theatrical Inc. products are not to be considered
compliant with agency requirements until the final OEM equipped products are tested
and certified separately for the applicable requirements.
End-use compliance testing and certification is the responsibility of the OEM user.
