5907 Multiverse Receiver Card, 900MHz
21
7.7 Approved Antennas
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that required for
successful communication. This device has been designed to operate with the antennas listed
below. Antennas not included in this list are strictly prohibited for use with this device. The antenna
impedance is 50 ohms. The integrator must provide the ability to select an antenna in the end
product and provide t
he following antenna information as to its use in the product’s user manual.
The cards can be configured ONLY with any one of the approved antennas below for fixed, point-
to-point (one transmitter and one receiver) configuration. When the card is configured for point-to-
multipoint (one transmitter and multiple receivers, receivers talk to transmitter only one at a time)
configuration, the card as a receiver can use any of the approved antennas.
When antennas ID2 is used, the user must select the antenna
type “Panel” using RDM.
When antennas ID3 is
used, the user must select the antenna type “Yagi” using RDM.
The integrator must include instructions in the product’s user manual as to the setting of this RDM
parameter. For example:
“When using a panel antenna, you must select ‘Panel Antenna’ in the
antenna options using RDM.
”
Table 17: Approved Antennas
ID
Mfg
CTI
P/N
Model
Type
Connector
Gain
(dBi)
Freq.
(Hz)
1
TekFun
5980
JM10-SR
Omni Whip Tilt
RP-SMA
2/3
900M/2.4G
2
Tekfun
5981
PL-W26-08M
Panel
N Female
6.5/8.5
900M/2.4G
3
Tekfun
5982
LP-W28-110
Yagi
N Female
11
900M/2.4G
