7
addressing schemes, such as when being used in combination with other Color Kinetics™
power supplies like the PDS-150™
Pass Thru Mode is selected whenever the DMX Address switches are set to all 0s (000) and the
Config Switch is set to 0
Stand-Alone Effects Mode
In
Stand-Alone Mode
the PDS-750-TR will run various pre-programmed effects without need
for a console. This is very useful for events like parties or trade shows, where a constantly
running program is desired without the use of a console or show programming.
The unit is placed into Stand-Alone Mode using the Config BCD switch. When the unit is in
Stand-Alone mode, the DMX Address switches become Effect controls. Different Stand-Alone
Effects are selected via different setting combinations of the DMX Address switches and the
Config switch
Configuration Switch Settings for different Stand-Alone Effects
0
No Stand-Alone function. The System will operate normally in Pass-Thru or CB
Modes, depending on the DMX Address switch settings.
1
Fixed Color. The DMX address BCDs are used to adjust the red, green and blue
components. DMX 100s controls the red (0 is off and 9 is full), DMX 10s controls
green and DMX 1s controls blue.
2
Color Wash (forward). The color wash effect moves sequentially around the
spectrum of colors (Red, Magenta, Blue, Cyan, Green, Yellow & White) repeating the
same cycle over and over again at user definable speeds. The speeds are controlled
by setting the DMX 10s & ones to 1 of 48 possible settings. The following lists their
settings and approximate fade times.
0
.25 sec
1
.3 sec
2
.4 sec
3
.6 sec
4
1.25 sec
5
2.55 sec
6
4 sec
7
5 sec
8
10 sec
9
15 sec
10
20 sec
11
25 sec
12
30 sec
13
35 sec
14
40 sec
15
45 sec
16
50 sec
17
1 min
18
1.2 min
