4
Figure 1, PDS-750-TR, Front Panel
Front Panel Controls
The PDS-750-TR front panel controls will generally look familiar to most professional users, with
a Pilot/Status Light, 3 BCD DMX Address Switch array, and a system reset switch. In addition,
the unit is provided with a Configuration BCD, overload indicators, and a Mini-Zapi™ Switch. All
the control functions are described below:
1. Pilot / Status Light:
On = Power Present, System running
Blinking = No DMX
Solid = DMX Present
Green = CB Mode
Orange = Pass Thru Mode
Alternating Red/Green = Stand Alone Mode
2. Reset Switch: Press to reset the PDS-750-TR’s system microprocessor
3. DMX Address Switches: Left to right =
100’s, 10’s, 1’s
Set address to 000 for Pass Thru mode
Set address to any valid address 001 – 476
1
for CB mode
4. Configuration Switch: Selects Stand-Alone Routines. Also may be used for special
functions
5. Channel Overload Indicator: Lights if internal circuit breaker is tripped, indicating an
overloaded output. If tripped, disconnect load and allow unit to cool (~ 2 minutes). Circuit
1
The unit may be addressed to start at
any
DMX value up to 512, however addresses above 476 will
waste outputs, as DMX values will not exist for all outputs.
PDS-750 TR
