7400-5708 Vero Net™ Transceiver
Installation and Quick Start Guide
Rev 1.2
© 2012, City Theatrical, Inc.
475 Barell Ave., Carlstadt, NJ 07072
Voice: 800-230-9497, 201-549-1160
Fax: 201-549-1161
INSTALLING THE 7400-5708 SHOW DMX VERO NET TRANSCEIVER
Installation
Install the SHoW DMX Vero Net Transceiver in a suitable location, following the instructions
below. When selecting a mounting location, note that for best results the antennas in your
system must be within sight of each other.
Warning
To avoid electric shock, do not energize any circuits before all internal and external electrical
and mechanical clearances are checked to assure that all assembled equipment functions
safely and properly.
Important use notes
This unit must be used with voltages below 600V
This unit must be installed in accordance with the National Electrical Code, ANSI/NFPA 70,
where the ambient temperature does not exceed 40°C (104°F) maximum.
Grounding
This enclosure has been provided with a ground bond jumper for ground connection between
the back box and the cover. This jumper must be installed as shown in the drawing below,
using the provided hardware.
Mounting Bracket
The provided mounting Bracket Base can be mounted on a surface or a vertical pipe. For
surface mounting, the Bracket base is provided with slots and holes suitable for #10 / M4
screws or similar fasteners.
Surface Mounting
Mount the Mounting Bracket Base in the desired location using four x #10 / M4 screws (by
others, as above).
Page 1
