Page
6 of 7
Configu
512 termination On or Off. Turn On for end-of-line DMX512
onnection.
Receiver (Rx) On, or Transmitter (Tx) Off. Selects Receiver or Transmitter
peration
3, Reset: On or Off. Switch On to Reset
and install Host
nd radio firmware upgrades from a connected USB Memory device.
tore the system to factory default settings:
D to blink rapidly
3. Switch P1 to Off
sceiver for use as a transmitter and at least one Vero Net Transceiver for
ave
rs open so you have access to the System Settings controls and internal
EDS.
re using as a transmitter by setting P4 to the Transmitter (Tx) position (switch OFF).
a receiver(s) are correctly set with P4 set to
e Receiver (Rx) position (switch ON).
Latency broadcast mode (this
HoW ID matches 5702 SHoW DMX SHoW Baby).
ower up the system and apply DMX512 control to the transmitter.
heck that the Data present LEDs on all units are lit and solid.
onfirm the In Range LED on all receivers is lit.
ration switches:
P5, DMX Term: DMX
c
P4, Rx/Tx:
o
P
P2 Bootloader: On or Off. Sets the unit to Bootloader mode to upload
a
P1 Default: On or Off. To res
1. Set P1 Default to On
2. Wait for PCBA LE
QUICK SETUP
For a basic 7400-5708 SHoW DMX Vero Net System you will need one 7400-5708 SHoW
DMX Vero Net Tran
use as a receiver.
1. Install the Vero Net units as shown in the installation instructions, including all DMX
and power connections. Locate the units so the antennas are within sight of each
other (if you are using directional or other special use antennas, consult the Manual
and SHoW DMX Neo Installation and Application Guide for installation details). Le
the cove
L
2. All Vero Net units are shipped configured as receivers. Configure the Vero Net unit you
a
3. Confirm the Vero Net(s) you are using as
th
4. Verify that all Vero Net units in the system are set to the same SHoW ID. The SHoW
DMX Vero Net Transceiver is preset at the factory with SHoW ID 201 for Adaptive
Spread Spectrum Frequency Hopping and Neo Low
S
5. P
6. C
7. C
