Citrix SD-WAN 110-WiFi-SE Quick Start Guide
13
To configure the management IP address for a hardware SD-WAN appliance, do the
following:
Note
You must repeat the following process for each hardware appliance you want to add to
your network.
1. If you are configuring a hardware SD-WAN appliance, physically connect the
appliance to a PC.
•
If you have not already done so, connect one end of an Ethernet cable to the
Management Port on the appliance, and the other end to the default
Ethernet port on the PC.
Note
Ensure that the Ethernet port is enabled on the PC you are using to connect
to the appliance.
2. Record the current Ethernet port settings for the PC you are going to use to set the
appliance management IP address.
You need to change the Ethernet port settings on the PC before you can set the
appliance management IP address. Record the original settings so you can restore
them after configuring the management IP address.
3. Change the IP address for the PC.
On the PC, open your network interface settings and change the IP address for
your PC to the following:
•
192.168.100.50
4. Change the Subnet Mask setting on your PC to the following:
•
255.255.0.0
5. On the PC, open a browser and enter the default IP address for the appliance.
Enter the following IP address in the address line of the browser:
•
192.168.100.1
Note
Use Google Chrome browser when connecting to a SD-WAN appliance.
Ignore any browser certificate warnings for the Management Web Interface.
