Citrix SD-WAN 110-WiFi-SE Quick Start Guide
12
Connect the power cable to one of the inlet receptacles on the back of the appliance, and
connect the other end of the power cable to a power outlet.
Connecting the appliance to the network
Connect the interfaces on the appliance to the network ports on the appropriate
switches by using Ethernet/fiber optic cables.
Note
: Citrix SD-WAN 11.1 supports day-0 provisioning and day-n management of the
appliance through both management and data ports.
Warning:
Connecting multiple network ports to the same switch or VLAN can result in a
network loop.
Setting up the appliance
1. If you are configuring the appliance using Zero Touch Deployment (ZTD), see
Zero
Touch
.
2. If you are configuring a hardware SD-WAN appliance, physically connect the
appliance to a PC. For more information, see
Setting up the Appliance Hardware
.
To set up your Citrix SD-WAN appliance hardware, do the following:
1. Set up the chassis.
For desktop installation, place the chassis on a flat surface. Ensure that there is a
minimum of two inches of clearance at the sides and back of the appliance for
proper ventilation.
2. Connect the Power.
a. Ensure that the power switch is set to off.
b. Plug the power cord into the appliance and an AC outlet.
c. Press the power button located on the front of the appliance.
3. Connect the appliance Management Port to a personal computer.
You need to connect the appliance to a PC in preparation for completing the next
procedure, setting the Management IP address for the appliance.
Note
Before you connect the appliance, ensure the Ethernet port is enabled on
the PC. Use an Ethernet cable to connect the SD-WAN appliance
Management Port to the default Ethernet port on a personal computer.
已註解
[PK[2]:
The ZTD procedure will be updated as per
the new 11.1.0 in-band provisioning feature. The link will be
updated when th release happens and the document is
published.
